LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1995 >> Firebird Formula, 2D Convertible, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical 3.8L V6 - VIN [K] >> Removal & Installation >> Cylinder Head >> Removal

Cylinder Head: Removal

  1. Remove upper and lower intake manifolds. See INTAKE MANIFOLD (UPPER)  and INTAKE MANIFOLD (LOWER)  . Remove exhaust manifold. See EXHAUST MANIFOLD  .
  2. On front cylinder head applications, disconnect spark plug wires. Remove engine lift bracket and rocker arm cover. Remove exhaust crossover pipe and cooling fan. Remove alternator, ignition coil and bracket. Remove A/C compressor bracket bolt.
  3. On rear cylinder head, disconnect spark plug wires. Remove exhaust crossover pipe. Remove power steering pump with hoses attached and position aside. Remove heater pipe from front cover housing. Remove transaxle fill tube.
  4. Remove rocker arms, push rods and guide plates. Refer to ROCKER ARMS & PUSH RODS  . Remove cylinder head bolts, cylinder head and gasket.
scientia non olet · About LEMON Manuals