LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1995 >> Firebird Formula, 2D Convertible, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Removal & Installation >> Sir Coil Assembly R & I >> Removal

Sir Coil Assembly R & I: Removal

  1. Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS  . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM  .
  2. Remove inflator module. See AIR BAG (INFLATOR) MODULE  . Remove horn contact wire from steering column. Remove steering wheel. See STEERING WHEEL  . DO NOT install puller bolts too far, as damage to coil assembly can result.
  3. Remove coil assembly retaining ring from steering shaft. Grasp clear plastic wire protector shield on underside of steering column, and slide downward. Partially remove coil assembly from end of steering wheel shaft and allow coil to hang freely. Note orientation to steering column housing before removal.
  4. Remove wave washer from steering shaft. Using Shaft Lock Remover (J-23653-C), depress shaft lock and remove shaft lock retaining ring. Remove shaft lock plate and upper bearing spring. Remove turn signal canceling cam.
  5. Remove hazard knob and attaching screw. Remove turn signal switch arm. Remove 3 turn signal switch screws and partially withdraw switch. Disconnect any remaining electrical connectors. Attach mechanics wire to coil assembly lower connector (at base of steering column) and carefully pull wire through gear shift lever bowl, column housing and lock housing cover.
scientia non olet · About LEMON Manuals