LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1995 >> Firebird Formula, 2D Convertible, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Removal & Installation >> Sir Coil Assembly R & I >> Installation

Sir Coil Assembly R & I: Installation

  1. Carefully feed coil assembly wire and lower connector through lock housing cover, column housing and gear shift lever bowl and allow coil assembly to hang freely.
    NOTE: Use care not to pinch wires when installing components. After wire is fed through, attach CAUTION tag to wire near connector at base of steering column. Tag is included in coil assembly repair kit.
  2. Install turn signal switch and torque screws to 30 INCH lbs. (3.4 N.m). Install turn signal switch arm and torque attaching screw to 20 INCH lbs. (2.3 N.m).
  3. Install hazard knob and attaching screw. Install turn signal canceling cam and shaft lock plate. Install shaft lock retaining ring. Using lock plate compressor, align block tooth on shaft, and depress shaft lock plate. Install wave washer.
  4. Ensure coil assembly hub and steering shaft are centered. Coil assembly will become uncentered if column is separated from steering gear and is allowed to rotate, or if centering spring is depressed, allowing hub to rotate while coil assembly is removed from column.
  5. Install coil assembly, using horn tower on canceling cam to align hole on inner ring of coil and projections on steering column housing with projections on outer ring of coil. To complete installation, reverse removal procedure. Reactivate air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM  .
scientia non olet · About LEMON Manuals