Removal (Eldorado, Riviera and Seville)
- Raise vehicle on frame contact hoist. Remove wheels. Remove and support calipers. Remove necessary suspension components as required. Remove ELC height sensor connector and ELC compressor connector from wiring harness.
- Remove ELC compressor air intake filter from body. Remove intermediate parking brake cable from equalizer. Position cable clear of crossmember assembly.
- Remove brake crossover pipe retainer screws. Remove right rear brake hose retainer bolt and crossover pipe. Remove ABS wheel speed sensor and brackets.
- Support rear crossmember assembly with jackstands. Remove crossmember forward arm mounting bolts, upper mounting bolts and lower insulators. See Fig 1 . Slowly raise vehicle. Ensure brake lines, hoses and calipers are not damaged when crossmember is lowered.