Rear Suspension CROSSMEMBER Bushings: Installation

1. Position new bushing in outside of leading arm. Position bushing with indentations positioned at 12 and 6 o'clock positions. See Fig 1 . Install Spacer (J-21474-25 ) between leading arm flanges.
2. Position Installer (J-35739-3 ), Receiver (J-21474-5 ), Nut (J-21474-18 ) and Bolt and Bearing (J-21474-19 ) on leading arm. See Fig 1 . Tighten nut to install bushing into leading arm, until bushing flange seats against leading arm.

Fig 1: Removing & Installing Crossmember Leading Arm Bushings Eldorado, Riviera and Seville