LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1993 >> Bonneville SE >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Control Arm >> Removal (Bonneville, DeVille/Sixty-Special, Eighty-Eight, LeSabre, Ninety-Eight, Park Avenue)

Removal (Bonneville, DeVille/Sixty-Special, Eighty-Eight, LeSabre, Ninety-Eight, Park Avenue)

  1. Raise and support vehicle. Remove wheel. Remove ELC height sensor link from right control arm (if equipped). Remove parking brake cable retaining clip from left control arm. Separate suspension adjustment link from control arm. See SUSPENSION ADJUSTMENT LINK  .
  2. Remove coil spring. See COIL SPRING & INSULATORS  . Separate ball joint from control arm. Remove ball joint cotter pin and nut. Invert nut and install with flat portion facing upward. DO NOT tighten nut.
  3. Install Puller (J-34505 ) and separate ball joint from control arm by backing off inverted nut against puller. Remove control arm retaining bolts. Remove control arm.
scientia non olet · About LEMON Manuals