Removal (Outer Control Arm Bushing) Eldorado, Riviera and Seville

For on-car service, follow steps for control arm removal but DO NOT loosen or remove inner control arm retaining bolts. See CONTROL ARM . Install Spacer Set (J-35739-1 ) between control arm flanges. Use wide spacer for outer bushing removal.
Coat threads of bolt and bearing with grease. Install Remover (J-35739-2 ), Receiver (J-21474-5 ), Nut (J-21474-18 ) and Bolt and Bearing (J-21474-19 ) on control arm. See Figure . Tighten nut to remove bushing.