LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1993 >> Bonneville SE >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Control Arm Bushing >> Removal (Bonneville, DeVille/Sixty-Special, Eighty-Eight, LeSabre, Ninety-Eight, Park Avenue)

Removal (Bonneville, DeVille/Sixty-Special, Eighty-Eight, LeSabre, Ninety-Eight, Park Avenue)

  1. Install Spacer (J-22222-5 ) or (J-33793-5 ) according to bushing size in control arm. Position Receiver Tube (J-25317-2 ) and Cap (J-29376-7 ) on outside of control arm. See Figure . Ensure receiver tube does not contact bushing flange. Coat threaded portion of Bolt and Bearing (J-21474-19 ) with grease.
  2. Install bolt through receiver, cap and bushing. Install Remover (J-22222-2 ) or (J-28685-2 ) on bolt at inner side of control arm with small end contacting bushing.
  3. Place bearing on bolt, and install Nut (J-21474-18 ). Tighten nut to remove bushing from control arm.
scientia non olet · About LEMON Manuals