Installation (Eldorado, Riviera and Seville)
- Position new bushing on control arm. Install bushing from outside of control arm inward. Install wide end of spacer between control arm flanges.
- Coat threads of bolt and bearing with grease. Place installer, receiver, nut, bolt and bearing on control arm. See Figure . Tighten nut until bushing flange seats against control arm.
- To install, position new bushing in control arm. Bushing must be installed from outside of control arm and drawn inward. Install narrow end of Spacer Set (J-35739-1 ) between control arm flanges.
- Position Installer (J-28576-1 ), Receiver (J-21474-5 ), Nut (J-21474-18 ), Bolt and Bearing (J-21474-19 ). See Fig 1 . Tighten nut to install bushing until bushing flange seats against control arm.