Installation (Bonneville, DeVille/Sixty-Special, Eighty-Eight, LeSabre, Ninety-Eight, Park Avenue)

Install new bushing in control arm with flanged end facing outward. Install proper sized spacer on bushing. Position receiver tube and cap on inside of control arm.
Center receiver tube over hole. Coat threaded portion of bolt and bearing with grease. Install bolt through receiver, cap and bushing. Place installer on bolt at outer side of control arm with large end contacting bushing flange.
Place bearing on bolt and install nut. Bearing must be positioned between nut and installer. Tighten nut and draw bushing into control arm until bushing flange seats firmly against control arm.

Fig 1: Removing & Installing Control Arm Bushings Bonneville, DeVille/Sixty-Special, Eighty-Eight, LeSabre, Ninety-Eight, Park Avenue

NOTE: On "E" & "K" bodies, outer control arm bushings can be replaced without removing control arm. If inner control arm bolts are not disturbed, rear wheel alignment will not be changed by outer bushing replacement.