Sir Coil Assembly: Installation
- Carefully feed coil assembly wire and lower connector through lock housing cover, column housing and gear shift lever bowl, and allow coil assembly to hang freely. Ensure slack is never present in coil assembly wire in steering column, otherwise coil assembly wire damage may occur.
- Install turn signal switch and switch arm. Tighten attaching screws to specification. See TORQUE SPECIFICATIONS TABLE at the end of this article.
- Install hazard knob and attaching screw, turn signal canceling cam, and shaft lock plate. Install shaft lock retaining ring. Using lock plate compressor, align block tooth on shaft and depress shaft lock plate. Install wave washer. Ensure coil assembly hub and steering shaft are centered. Coil assembly will become uncentered if column is separated from steering gear and allowed to rotate or if centering spring is depressed, allowing hub to rotate while coil assembly is removed from column.
- Install coil assembly using horn tower on canceling cam to align hole on inner ring of coil and projections on steering column housing with projections on outer ring of coil. To complete installation, reverse removal procedure. Ensure system is functioning properly. See SYSTEM OPERATION CHECK.