LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1993 >> Bonneville SE >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.8L "3800" V6 - VIN [L] >> Removal & Installation >> Flywheel >> Installation

Removal & Installation: Flywheel: Installation

  1. Install flywheel. Refer to TORQUE SPECIFICATIONS TABLE.
  2. Install dial indicator on engine block and check flywheel runout at three attaching bosses. The crankshaft end-play must be held in one direction during this check. Runout should not exceed 0.381 mm (0.015 inch).
  3. If runout exceeds 0.381 mm (0.0015 inch), attempt to correct by tapping high side with mallet.
  4. If condition cannot be corrected, replace flywheel.
scientia non olet · About LEMON Manuals