LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1993 >> Bonneville SE >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.8L "3800" V6 - VIN [L] >> Removal & Installation >> Crankshaft Rear Oil Seal >> Installation

Crankshaft Rear Oil Seal: Installation

  1. Apply engine oil to ID and OD of new seal. Install seal using Seal Installer (J-38196). Slide new seal over mandrel until back of seal bottoms squarely against collar of tool.
  2. Install seal using following instructions: Attach tool to crankshaft by hand, or tighten attaching screws to 5 N.m (60 lb.in.). Turn T-handle of tool so that collar pushes seal into the bore, and continue until the collar is seated tight against the case. Loosen the T-handle of the tool. Remove attaching screws.
  3. Install flywheel.
scientia non olet · About LEMON Manuals