Diagnostic Trouble Code Identification/Availability
The following table lists only those codes available for this engine, as well as their identifications.
The diagnostic trouble code charts are used to find and repair problems which the Diagnostic Circuit Check has found. If the Diagnostic Circuit Check shows that codes have been stored, proceed to the appropriate code chart. If more than one code has been stored, always start code diagnosis with the lowest code number and work upward.
These charts are not contained in this article. They can be found in the appropriate article in the ENGINE PERFORMANCE Section.
DIAGNOSTIC TROUBLE CODE IDENTIFICATION/AVAILABILITY
| Code | Identification |
|---|---|
| 13 | Oxygen Sensor Circuit (Open Circuit) |
| 14 | Coolant Temperature Sensor Circuit (High Temperature Indicated) |
| 15 | Coolant Temperature Sensor Circuit (Low Temperature Indicated) |
| 21 | Throttle Position Sensor (TPS) Circuit (Signal Voltage High) |
| 22 | Throttle Position Sensor (TPS) Circuit (Signal Voltage Low) |
| 23 | Manifold Air Temperature (MAT) Sensor Circuit (Low Temperature Indicated) |
| 24 | Vehicle Speed Sensor (VSS) Circuit |
| 25 | Manifold Air Temperature (MAT) Circuit (High Temperature Indicated) |
| 32 | Exhaust Gas Recirculation (EGR) Circuit |
| 33 | Mass Air Flow (MAF) Sensor Circuit (Grams/Second High) |
| 34 | Mass Air Flow (MAF) Sensor Circuit (Grams/Second High) |
| 41 | Cylinder Select Error (Faulty or Incorrect MEM-CAL) |
| 42 | Electronic Spark Timing (EST) Circuit |
| 44 | Oxygen Sensor Circuit (Lean Exhaust Indicated) |
| 45 | Oxygen Sensor Circuit (Rich Exhaust Indicated) |
| 51 | PROM Error (Faulty or Incorrect PROM) |
| 52 | CALPAK Error (Faulty or Incorrect CALPAK) |
| 53 | System Over Voltage |
| 54 | Fuel Pump Circuit (Low Voltage) |
| 55 | ECM Error |