Crankshaft Rear Oil Seal: Installation
- Clean mating surfaces of case and retainer assembly. Install new gasket on studs in engine case. It is not necessary to use any type of sealant to retain gasket in place.
- Install retainer to case bolts, torque bolts to 90-120 INCH lbs. (10-13 N.m). Install transmission. Inspect oil pan gasket for damage. Replace gasket if necessary. Apply a small amount of 1052751 or equivalent to front and rear corners of oil pan.NOTE: Only a small amount of sealant is required. Excessive amounts of sealant may cause a problem with proper sealing of oil pan.
- Install oil pan bolts. Install rear main seal using tool J-35621 as previously outlined. See Fig 1.