Valve Arrangement
E-I-I-E-E-I-I-E (Both banks, Front-to-rear).
- To adjust valves, rotate crankshaft to No. 1 firing position and adjust following valves:
- Intake No. 1, 2, 5 and 7.
- Exhaust No. 1, 3, 4 and 8.
- Adjust valves by backing off adjusting nut until lash is felt at push rod, then tighten until lash is removed. Tighten adjusting nut an additional one full turn.
- Rotate crankshaft to No. 6 firing position. Adjust following valves:
- Intake No. 3, 4, 6 and 8.
- Exhaust No. 2, 5, 6 and 7.
- When adjustment is complete, install valve covers. Start engine and check timing.