Intake Manifold: Removal
- Disconnect negative battery cable. Drain cooling system. Remove air cleaner. Remove heater, upper radiator hoses and upper alternator bracket. Remove cruise control servo and bracket, if equipped.
- Disconnect carburetor linkage, throttle valve linkage (A/T), fuel line, vacuum lines and electrical wiring at manifold. Disconnect right bank spark plug wires at plugs. Remove carburetor.
- Remove distributor cap and wires. Mark position of rotor and remove distributor. Remove A/C compressor and bracket, if equipped. Remove EGR solenoids and bracket. Remove dipstick tube at alternator adjusting brace.
- Disconnect Computer Command Control (CCC) wiring harness and lay aside. Disconnect fuel lines at air injection control valve bracket. Remove manifold bolts and intake manifold.