Instrument Panel - Electronic: Testing: Tachometer
- Disconnect tachometer connector at distributor. Connect mating cable from Instrument Panel Tester (J-33431) to connector just removed. Plug in tester and set to "ON" and "54 MPH". Place ignition switch in "RUN" position.
- Tachometer should read 900 RPM for V8 engine or 1350 RPM for V6 engine. If tachometer indicates correctly, check for intermittent problem or bad connections.
- If tachometer does not indicate correctly, disconnect instrument panel tester and reconnect distributor. Place ignition switch in "RUN" position, leaving engine off.
- Measure voltage at circuit No. 121 (White wire) of instrument panel (connector No. 1, terminal F). See Figure . If voltage is above 10 volts, replace instrument cluster. If voltage is below 10 volts, check circuit No. 121 (White wire) to distributor.