Assemble

1. Press output shaft bearing onto output shaft using tool No. J6133-A or equivalent.




2. Position 1st gear onto shaft. Place blocker ring onto gear cone, then press 1-2 synchronizer onto shaft using a piece of pipe of suitable diameter or other suitable tool. Do not press on sleeve, press on hub near shaft.

3. Install snap ring retaining 1-2 synchronizer, then place blocker ring into position.

4. Install 2nd speed gear onto shaft, then press 3rd/4th gear onto shaft using support plates and tool No. J-26943 or equivalent.

5. Press left hand bearing onto shaft using tool No. J-26942 or equivalent, then install retainer and torque to 37-55 ft. lbs.