LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1983 >> 2000 Sunbird Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL OHV - VIN [P] >> Removal & Installation >> Engine

Removal & Installation: Engine

  1. Disconnect battery cables. Drain cooling system and disconnect radiator hoses. Remove air cleaner. Disconnect accelerator and TV cables at throttle body. Disconnect ECM harness at engine.
  2. Disconnect all vacuum hoses and heater hoses at engine. Remove exhaust heat shield, A/C adjustment bolt at motor mount, windshield washer bottle, and engine wiring harness at bulkhead.
  3. Remove all drive belts. Disconnect fuel hoses. Raise and support vehicle. If equipped, remove A/C compressor brace. Remove inner fender and flywheel splash shield. Remove A/C compressor from engine and position aside. Remove starter wires, front starter brace, and starter. If equipped, remove torque converter bolts.
  4. Remove crankshaft pulley. Remove crankshaft hub. Remove the oil filter. Disconnect the engine-to-transmission support bracket. Disconnect exhaust pipe at manifold and center hanger. Loosen muffler hanger. Remove TV/shift cable bracket.
  5. Remove 2 lower bellhousing bolts. Lower vehicle. Remove right front motor mount nuts. Remove alternator and adjusting brace. Remove master cylinder from booster and support out of way. Attach lifting device. Remove right front motor mount bracket.
  6. Disconnect upper bellhousing bolts. Remove power steering pump while lifting engine. Remove engine.