LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1983 >> 2000 Sunbird Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL OHV - VIN [P] >> Removal & Installation >> Camshaft Bearings >> Removal

Camshaft Bearings: Removal

  1. With camshaft and crankshaft removed, remove camshaft rear cover. Fasten connecting rods to side of engine to keep out of work area. Using Camshaft Bearing Remover (J-6098), fasten nut and thrust washer to end of threads.
  2. Insert Camshaft Bearing Remover (J-6098) pilot in camshaft front bearing and install puller screw through pilot. Install remover/installer (J-6098) with shoulder toward bearing with sufficient amount of threads engaged.
  3. Using an additional wrench to hold puller screw stationary, turn nut until bearing is pulled from block. Remove bearing from Remover/Installer (J-6098). Remove remaining bearings (except front and rear) in same manner.
  4. Insert pilot in camshaft rear bearing to remove rear intermediate bearing. Assemble Remover/Installer (J-6098) on driver handle and remove front and rear bearings by driving toward center of cylinder block.
scientia non olet · About LEMON Manuals