Reassembly & Installation
- Clean and inspect all parts. Install valve plunger and spring. Coat valve plug with sealer (Loctite 573 or equivalent) and install.
- Install pump gears with mark on outer pump facing front of engine. Install rear cover. Using a new "O" ring, install pick-up tube.
- Install a new gasket and reverse the removal procedure.
OIL PUMP SPECIFICATIONS
| Application | Inches (mm) |
|---|---|
| Idler Gear-to-Body Clearance | .004-.007 (.10-.17) |
| Drive Gear-to-Body Clearance | .013-.017 (.33-.43) |
| Gear-to-Cover Clearance | .001-.004 (.02-.10) |