LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1981 >> T1000 2D Hatchback, Automatic Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 1.6 Liter 4 Cylinder >> Pistons, Pins & Rings >> Piston & Rod Assembly >> Removal

Piston & Rod Assembly: Removal

  1. With cylinder head and oil pan removed, use a ridge reamer to remove any ridge or deposits on upper end of cylinder bore.
    NOTE: Piston must be at bottom of stroke and covered with cloth to collect cuttings.
  2. Inspect rods and caps for cylinder identification and mark as necessary. Remove rod cap and cover studs with rubber tubing to protect crankshaft and cylinder walls.
  3. Carefully push piston and rod assembly out top of cylinder block.
scientia non olet · About LEMON Manuals