LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1981 >> T1000 2D Hatchback, Automatic Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 1.6 Liter 4 Cylinder >> Cylinder Head & Manifolds >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. Install new head gasket over dowel pins with legend, "This Side Up" facing upward. Place head and manifold assembly on engine.
  2. Apply Loctite No. 514 or GM No. 1052357 Sealer (or equivalent) to top of head or cam carrier mating surfaces. Coat head bolts with engine oil and tighten in sequence. See Fig 1. Reverse removal procedure to complete installation.
    Fig 1: Cylinder Head Tightening Sequence
    G09352024Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals