LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1981 >> T1000 2D Hatchback, Automatic Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 1.6 Liter 4 Cylinder >> Crankshaft & Rod Bearings >> Rear Main Bearing Oil Seal >> Installation

Rear Main Bearing Oil Seal: Installation

  1. Install new seal in cylinder block, taking care to seat seal against rear main bearing bulkhead. Install rear main bearing cap.
  2. Install and tighten cap bolts and place suitable two part sealer in vertical grooves. Tap end of crankshaft rearward, then forward, and tighten main rear bearing cap to specifications. Remove excess sealer and reinstall oil pan.
scientia non olet · About LEMON Manuals