LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1981 >> T1000 2D Hatchback, Automatic Trans >> Repair and Diagnosis (Single Page) >> Electrical >> Motors, Switches, Relays >> Steering Column Switches - All Models >> Removal & Installation >> Ignition Switch >> Removal (General Motors)

Removal (General Motors)

  1. Steering column must be lowered or removed (tilt or telescope columns) or turn signal switch removed (standard column).
    NOTE: On tilt or telescope columns, steering wheel removal is not required.
  2. Position switch in "ACC" on tilt or telescope columns, or "OFF" on standard columns. If lock cylinder has already been removed, the actuating rod should be pulled up until it stops.
  3. On standard columns, push actuating rod down one detent ("OFF" position). Remove switch screws and lift switch from actuating rod and column.
scientia non olet · About LEMON Manuals