Electrical Test - "Resume" System

Check all fuses and connections. Adjust brake release valve and switch. Disconnect switch harness 3-wire connector at lower end of steering column. Check switch continuity using continuity chart.

"RESUME" SWITCH CONTINUITY CHART

Button	Slider	Continuity
Released	OFF	None
Release	ON	Blu-Blk
Released	RESUME	Brn-Blu-Blk
Half In	ON	None
Full In	ON	Brn-Blu
Releasing	ON	Brn-Blu-Blk

Disconnect electrical connector at resume valve. With transducer well grounded, connect an ohmmeter between ground and Brown/White wire in main wire harness. Resistance should read 27-31 ohms.
Disconnect main wiring harness from transducer. Connect ohmmeter between Dk. Green wire at transducer and Gray/Black wire at resume solenoid. Resistance should be 21-25 ohms. If not, check broke switch operation. If brake switch is okay, repair or replace harness as required.
Check for continuity between resume valve ground wire and ground. Repair if no continuity. Reconnect electrical connector at resume valve. With harness disconnected from transducer, connect battery voltage to Dk. Green wire. Resume valve should pull in. If not, replace valve.
Check transducer by measuring resistance from Dk. Green wire to ground. Resistance should be 5.3-6.3 ohms. Apply battery voltage to transducer hold terminal. Transducer solenoid should engage, and release upon removal of battery voltage. If not, replace solenoid.