Studebaker (1960-65)

Disconnect battery. On 6 Cyl. remove dipstick and tube and starter mounting capscrews (do not disconnect cables) and tie starter out of way. On V8, remove starter. On all models, remove clutch operating shaft. Remove transmission assembly. Disconnect engine rear support from crossmember. Raise engine at oil pan and remove crossmember. On V8, remove clutch housing cover plate. Remove clutch housing.

Mark flywheel and clutch for reassembly, remove attaching bolts, and remove clutch assembly.

CLUTCH DRIVEN DISC INSTALLATION CAUTION  - On 194" and 283" engines, driven disc is always  installed with the grease slinger on disc toward transmission (rear) side of assembly. This supersedes any previous information.