LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1966 >> GTO Eng CD WW, Not Available Trans >> Repair and Diagnosis (Single Page) >> Transmission >> Clutch >> Clutches - Borg & Beck >> Clutch Pedal Adjustment >> Studebaker (1962-65)

Studebaker (1962-65)

Brake pedal must first be properly adjusted and clutch pedal brought to the same height by turning clutch pedal stopscrew.

NOTE: On power brake cars, adjust so clutch pedal height is 6 1/4-6 1/2" from top of pedal pad to floor mat.

Turn adjusting nut on clutch over-center spring so spring length is 10", then adjust clutch pedal-to-bellcrank rod so there is 1/2" clearance between top end of bellcrank and body flange on front side of firewall. Now turn clutch operating rod adjusting nuts as necessary for 1/2-1" pedal free travel measured at pedal pad.

HILL HOLDER NOTE:  Check setting whenever clutch pedal adjusted and adjust operating rod so Hill Holder releases at same time clutch is engaged.

scientia non olet · About LEMON Manuals