LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 2000 >> Neon High Line, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Bleeding Brake System >> Bleeding Procedures >> Manual Bleeding

Manual Bleeding

  1. Fill master cylinder. Install clear vinyl bleeder hose onto bleed screw at first wheel to be serviced. See BRAKELINE BLEEDING SEQUENCE  table. Place other end of hose in clean transparent container.
  2. Partially fill container with clean brake fluid. Submerge end of hose in fluid. Open bleed screw 1-2 turns. Slowly depress brake pedal through its full travel.
  3. Close bleed screw. Release pedal. Pump pedal several times to push air toward wheel cylinders. Repeat procedure until brake fluid flows clear and free of bubbles. Proceed to next bleed screw of brake bleeding sequence.
NOTE: Check fluid level in master cylinder frequently when bleeding.
scientia non olet · About LEMON Manuals