Ignition Switch
- Remove instrument panel knee protector and steering column covers. Disconnect wiring connectors from ignition switch. Using an ohmmeter, check continuity at switch side of connector. See Fig 1 and Fig 2 . See IGNITION SWITCH CONTINUITY and IGNITION SWITCH CIRCUIT FUNCTIONS tables.
- Operate ignition switch while checking continuity between terminals. See Fig 1 and Fig 2 . Replace ignition switch assembly if continuity is not as specified.
IGNITION SWITCH CONTINUITY
| Switch Position | Continuity Between Terminals No. | |
|---|---|---|
| ACC | ||
| Connector C1 | No Continuity | |
| Connector C2 | 7 & 8 | |
| LOCK | ||
| Connector C1 | No Continuity | |
| Connector C2 | No Continuity | |
| OFF | ||
| Connector C1 | 1 & 2 | |
| RUN | ||
| Connector C1 | 1 & 2 | |
| Connector C2 | 3 & 4; 7 & 8; 7 & 9 | |
| START | ||
| Connector C1 | 1 & 2 | |
| Connector C2 | 1 & 2; 7 & 9; 7 & 10 | |
IGNITION SWITCH CIRCUIT FUNCTIONS
| Pin No. (Wire Color) | Function | |
|---|---|---|
| Connector C1 | ||
| 1 (RED/LT BLU) | Battery Feed To Ignition | |
| 2 (DK GRN/RED) | Ignition Switch Output (OFF/RUN/START) | |
| Connector C2 | ||
| 1 (BLK) | Ground | |
| 2 (GRY/DK BLU) | Red Brake Warning Light Driver | |
| 3 (PNK/BLK) | Battery Feed To Ignition | |
| 4 (BLK/ORG) | Ignition Switch Output (RUN) | |
| 5 | Not Used | |
| 6 | Not Used | |
| 7 (RED) | Battery Feed To Ignition | |
| 8 (BLK/WHT) | Ignition Switch Output (ACC/RUN) | |
| 9 (DK BLU) | Ignition Switch Output (START/RUN) | |
| 10 (YEL) | Ignition Switch Output (START) | |