Pump Initial Operation Check
For additional information, refer to POWER STEERING FLUID USAGE .
CAUTION:
The fluid level should be checked with engine off to prevent injury from moving components. Use only Mopar(R) Power Steering Fluid. DO NOT use automatic transmission fluid. DO NOT overfill.
Wipe filler cap clean, then check fluid level. The dipstick should indicate FULL COLD when fluid is at normal temperature of approximately 21-27°C (70-80°F).
- Fill pump fluid reservoir to proper level and let fluid settle for at least 2 minutes. Start engine and let run for a few seconds. Then turn engine off.
- Add fluid if necessary. Repeat above procedure until fluid level remains constant after running engine. Raise front wheels off ground. Start engine. Slowly turn steering wheel right and left, lightly contacting wheel stops.
- Add power steering fluid if necessary. Lower vehicle and turn steering wheel slowly from lock to lock. Stop engine. Check fluid level and refill as required. If fluid is extremely foamy, allow vehicle to stand a few minutes and repeat above procedure.