Cluster Lamps (1997)
- Disconnect and isolate negative battery cable. Remove instrument panel top cover. To service lamps, remove lamp boxes. See Figure.
- For cluster lamp locations and bulb identification, see Figure and BULB IDENTIFICATION (1997) . The indicator lamps use a bulb No. 103, and illumination lamps use a Bulb No. 194.
- To service vehicle theft LED, mask/lens needs to be removed. The vehicle theft LED is a socket/lamp unit. See MASK/LENS Removal & Installation . Remove cluster to service illumination bulbs. The bulbs can be remove from rear of cluster. See Figure. To remove oil gauge illumination lamp, speedometer PC board must be removed. See Figure.
BULB IDENTIFICATION (1997)
| Bulb No. | Application |
|---|---|
| 1 | Low Washer Fluid |
| 2 | Check Gauge |
| 3 | Brake/Park Brake |
| 4 | High Beam Indicator |
| 5 | Seat Belt |
| 6 | Airbag |
| 7 | Left Turn Signal |
| 8 | Right Turn Signal |
| 9 | Service Engine Soon |
| 10 | Low Tire |
| 11 | Low Fuel |
| 12 | CRUISE ACTIVE |
| 13 | Door/Decklid Ajar |
| 14 | Vehicle Theft |