Cleaning & Inspection

Wash components with cleaning solvent and dry with compressed air. DO NOT steam clean. Wash bearings with solvent and towel dry, or dry with compressed air. DO NOT spin bearings with compressed air. Cups and bearings must be replaced as sets only.

Fig 1: Removing Drain Plug

Courtesy of CHRYSLER CORP.

Fig 2: Idenfying Flex Plate Bolts

Courtesy of CHRYSLER CORP.

Fig 3: Flex Plate Backing Plate & Bolts

Courtesy of CHRYSLER CORP.

Fig 4: Bell Housing Drive Flange & Nut

Courtesy of CHRYSLER CORP.

Fig 5: Removing Drive Flange

Courtesy of CHRYSLER CORP.

Fig 6: Identifying Front Seal

Courtesy of CHRYSLER CORP.

Fig 7: Removing Rear Seal

Courtesy of CHRYSLER CORP.

Fig 8: Special Tool C-293-1

Courtesy of CHRYSLER CORP.

Fig 9: Bell Housing In Press

Courtesy of CHRYSLER CORP.

Fig 10: Removing Inner Bearing In Press

Courtesy of CHRYSLER CORP.

Fig 11: Removing Outer Bearing Cup

Courtesy of CHRYSLER CORP.

Fig 12: Removing Inner Bearing Cup

Courtesy of CHRYSLER CORP.

Fig 13: Installing Inner Bearing Cup

Courtesy of CHRYSLER CORP.

Fig 14: Install Outer Bearing Cup

Courtesy of CHRYSLER CORP.

Fig 15: Pressing On Shaft Bearing

Courtesy of CHRYSLER CORP.

Fig 16: Installing Drive Flange

Courtesy of CHRYSLER CORP.

Fig 17: Tightening Drive Flange Nut

Courtesy of CHRYSLER CORP.

Fig 18: Installing Inner Seal Over Seal Guide

Courtesy of CHRYSLER CORP.

Fig 19: Inner Seal Installer

Courtesy of CHRYSLER CORP.