LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1997 >> Prowler >> Repair and Diagnosis (Single Page) >> Suspension >> Rear Suspension >> Removal & Installation >> Shock Absorber >> Removal

Shock Absorber: Removal

  1. Raise vehicle on jackstand or centered on a frame contact type hoist.
    2. NOTE: When removing center cap from wheel do not use sharp or hard tool. Use of such a tool can mare finish on wheel and damage center cap.
  2. Remove center cap from wheel. Center cap is removed by inserting a trim stick into notch on center cap and prying it off wheel. See Figure .
  3. Remove tire and wheel assembly.
  4. Remove nut and bolt mounting shock absorber clevis to mounting bracket/isolator on lower control arm. See Figure .
  5. Remove bolt and nut attaching shock absorber to frame bracket. See Figure .
  6. Remove shock absorber/coil spring assembly from vehicle.
scientia non olet · About LEMON Manuals