LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1997 >> Prowler >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC Systems - Compressor Servicing >> NIPPONDENSO 10PA17 & 10PA17C 10-Cylinder >> Clutch Assembly >> Installation

Clutch Assembly: Installation

  1. Install clutch coil so pin in back of coil aligns with hole in front housing. Install snap ring. Install rotor and pulley assembly. Install snap ring and shims. Install clutch hub.
  2. Install dial indicator to measure clutch hub air gap. Apply battery voltage to energize clutch coil. Proper air gap clearance is .014-.026" (.36-.66 mm). Adjust shim thickness to obtain correct clearance. Install compressor shaft bolt. Tighten compressor shaft bolt to 10 ft. lbs. (14 N.m).
scientia non olet · About LEMON Manuals