LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1997 >> Prowler >> Repair and Diagnosis (Single Page) >> General Information >> Restraints >> Supplemental Inflatable Restraint System - Air Bag Deactivation Procedures >> General Motors >> Disabling & Activating Air Bag System >> Disabling & Activating System (Saturn)

Disabling & Activating System (Saturn)

NOTE: When fuse is removed and ignition switch is in ON position, AIR BAG warning light will be on. This is a normal operation and does not indicate an SIR system malfunction.
  1. Turn steering wheel to place wheels in straight-ahead position. Turn ignition switch to LOCK position, and remove key.
  2. Remove AIR BAG fuse from instrument panel junction block. Wait 10 minutes. Locate driver-side air bag module Yellow 2-pin connector near base of steering column. Remove Connector Position Assurance (CPA) clip and disconnect Yellow 2-pin connector at base of steering column.
  3. Passenger-side air bag module connector is located under upper instrument panel trim panel. To access connector, locate upper panel screw caps at center of instrument panel. Remove screw caps and upper trim panel screws.
  4. Remove upper trim panel by lifting up on rear edge to release clips. Pull panel rearward out of clips at bottom of windshield. Remove upper trim panel insulator. Locate passenger-side air bag module Yellow 2-pin connector in center of instrument panel. Remove CPA clip and disconnect connector.
  5. To activate air bag system, turn ignition switch to LOCK position and remove key. Connect Yellow 2-pin connectors, and install CPA clips. To complete installation, reverse removal procedure. Install AIR BAG fuse. Turn ignition switch to RUN position. Ensure AIR BAG warning light flashes 7 times and then goes out.
scientia non olet · About LEMON Manuals