Emissions Maintenance Reminder Reset Procedure

NOTE: If any other scan tool is used, use scan tool manufacturer's instructions.

Attach DRB-II tester to diagnostic connector.
Turn ignition on but do not start engine.
Access SELECT SYSTEMS function of DRB-II tester.
Select appropriate engine.
Select with or without A/C.
Select FUEL & IGNITION.
Select ADJUSTMENTS.
Select RESET EMR LIGHT.
Reset EMR light.
When DRB-II is finished resetting light, DRB-II display will read EMR LIGHT IS RESET.

NOTE: If Single Module Engine Controller (SMEC) or Single Board Engine Controller (SBEC) is replaced, vehicle mileage must be programmed back into the SMEC/SBEC. DRB-II tester MUST be used for this procedure. If the following procedure is not performed, EMR light will not turn on at the proper mileage intervals.