LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1997 >> Prowler >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal. & Installation >> Motors, Relays & Solenoids >> Duty Cycle EVAP Purge Solenoid (1997) >> Removal & Installation

Removal & Installation

NOTE: The duty cycle EVAP purge solenoid is mounted on the right side of vehicle near dash panel. The top of the solenoid has the word TOP on it. The solenoid will not operate unless it is installed correctly.
  1. Disconnect electrical connector from EVAP solenoid. See Fig 1. Disconnect vacuum harness from solenoid. Lift solenoid up off of bracket.
  2. Install solenoid onto bracket with the top side up. The upper end of the solenoid has the word TOP on it. Ensure solenoid does not contact other surfaces or components. The solenoid could make a clicking sound if it contacts other surfaces or components.
  3. Attach electrical connector to solenoid. Connect vacuum harness to solenoid.
Fig 1: Duty Cycle EVAP Purge Solenoid Removal
G00064612Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals