LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1997 >> Prowler >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal. & Installation >> Emission Systems >> Proportional Purge Solenoid (1999) >> Removal & Installation

Removal & Installation

NOTE: The top of the solenoid has TOP printed on it. The solenoid will not operate unless it is installed correctly.
  1. Remove solenoid from bracket by pulling up on solenoid. See Fig 1. Disconnect electrical connector from solenoid. Disconnect vacuum tubes from solenoid.
  2. Connect vacuum tube to solenoid. Connect electrical connector to solenoid. Install solenoid on bracket.
Fig 1: Identifying Proportional Purge Solenoid & Test Port
G00064613Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals