LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1997 >> Prowler >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal. & Installation >> Emission Systems >> EVAP Purge Solenoid Valve (1997) >> Removal & Installation

Removal & Installation

NOTE: The EVAP purge solenoid valve is located on a bracket attached to the right side engine compartment near the dash panel. See Figure.
  1. Slide valve off of bracket. Disconnect the electrical connector. Disconnect the vacuum hoses from the valve.
  2. Connect the vacuum hoses to the valve. Connect the electrical connector to the valve. Slide valve onto bracket.
scientia non olet · About LEMON Manuals