LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1997 >> Prowler >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.5L V6 Engine >> Removal & Installation >> Exhaust Manifold >> Installation (Right)

Installation (Right)

  1. Install lower heat shield to manifold. Tighten attaching screw to 12 N.m (105 INCH lbs).
  2. Position a new V-band clamp onto manifold between the outlet flange and oxygen sensor boss.
  3. Install manifold to cylinder head. Tighten manifold starting at center bolts and working outwards to 23 N.m. (205 INCH lbs).
  4. Install upper head shield to manifold and tighten attaching screws to 12 N.m. (105 INCH lbs).
  5. Install oxygen sensor to manifold and tighten to 28 N.m. (20 ft. lbs). Connect oxygen sensor electrical connector.
  6. Attach catalytic converter to manifold using a new V-band clamp and tighten to 11 N.m. (100 INCH lbs).
  7. Lower vehicle and install air conditioning compressor mounting bracket to engine.
  8. Install compressor to mounting bracket. Tighten compressor bolts to 28 N.m. (250 INCH lbs).
  9. Install air conditioning compressor drive belt.
  10. Install right headlamp module.
  11. Install right hood side panel.
  12. Connect negative cable to battery.
scientia non olet · About LEMON Manuals