LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1997 >> Prowler >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System & Automatic Transmission Cooling System >> Removal & Installation >> Thermostat - 1999-2002 Prowler >> Installation

Thermostat - 1999-2002 Prowler: Installation

NOTE: Install thermostat with bleed valve located at 12 o'clock position.
  1. Clean gasket sealing surfaces. Install thermostat and gasket into thermostat housing. For ease of installation, install bolts in housing for thermostat and gasket retention. Install thermostat and housing to cylinder block. Tighten bolts to 105 INCH lbs. (12 N.m). Connect heater and radiator hoses. Install hose clamps.
  2. Install oil pressure switch and oil filter. Connect electrical connector to engine oil pressure switch. Lower vehicle and connect negative cable to battery. Refill cooling system.
scientia non olet · About LEMON Manuals