- Thoroughly clean master cylinder and brake fluid reservoir. Remove master cylinder from vacuum booster. Using a syringe or other equivalent tool, empty as much brake fluid as possible from brake fluid reservoir.
CAUTION:
When mounting master cylinder in vise, clamp master cylinder only by mounting flange. DO NOT clamp on primary piston, seal or body of master cylinder.
- Mount master cylinder in a vise. See Figure
. Using a pin punch remove 2 roll pins retaining brake fluid reservoir to master cylinder. See Figure
.
CAUTION:
When removing fluid reservoir from master cylinder do not pry reservoir off with a tool, damage to fluid reservoir may result.
- Rock brake fluid reservoir from side to side while pulling upward to remove it from sealing grommets in master cylinder. See Figure
.
CAUTION:
The brake fluid reservoir to master cylinder sealing grommets can not be reused. Discard sealing grommets after removing them from master cylinder.
- Remove master cylinder-to-fluid reservoir sealing grommets from master cylinder. See Figure
.