LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1997 >> Prowler >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Warning Systems >> Horn Systems >> Diagnosis & Testing >> Fuse Blown

Fuse Blown

  1. Remove horn relay located in PDC. Disconnect wire connectors at horns.
  2. Using an ohmmeter, check for continuity to ground at terminal No. 2 of relay connector. If continuity to ground exists, there is a short to ground. Repair circuit as necessary. If no continuity exists, go to next step.
  3. Check for continuity to ground at terminal No. 5 of relay connector. If continuity to ground exists, there is a short to ground. Repair circuit as necessary. If no continuity exists, connect wire connectors to horns and go to HORN RELAY  test.
scientia non olet · About LEMON Manuals