Rocker Arm & Valve Lash Adjuster: Inspection

Disassemble rocker components. Keep parts in order for reassembly. Inspect components for wear and damage. See VALVE TRAIN  under OVERHAUL. Assemble rocker shaft components in original locations. Note identification mark and position of rocker arm offset. See Fig 1.

Fig 1: Installing Rocker Arm Shaft Assembly (1.5L)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

1. Inspect rocker arms and shafts for wear and damage. Check distributor drive gear for tooth damage and wear. Replace components as necessary.
2. Check camshaft journal diameter and lobe height. Replace camshaft if journal diameter and lobe height are not within specification. See CAMSHAFT  table under ENGINE SPECIFICATIONS.