Rocker Arm Shaft Assembly (1.5L)

Note location of all components for reassembly reference. Remove bolts from shafts, and separate components. Springs are only on intake rocker arm shaft. On all models, inspect components for damage and wear.
To install components, reverse removal procedure. Install components into original locations. Rocker arms are marked "A" to "D" for location. See Figure and Fig 1 . Ensure large chamfer on rocker arm bore is facing timing belt side of engine.
Tighten rocker arm assembly bolts to specification. See TORQUE SPECIFICATIONS . Adjust valve clearance. Refer to, under ADJUSTMENTS, VALVE CLEARANCE ADJUSTMENT .

Fig 1: Identifying Rocker Arm Components (1.5L)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.