LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1992 >> Sundance Base, 2D Hatchback, 2.2 D, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Disc & Drum) >> Removal & Installation >> Axle Hub Bearings: Fwd >> Removal (FWD)

Removal (FWD)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1991 Plymouth Sundance, 1991 Plymouth Acclaim, 1991 Dodge Spirit, 1991 Dodge Shadow, and 1991 Dodge Dynasty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove caliper and rotor. See FRONT BRAKE CALIPER & PADS  and FRONT BRAKE ROTOR  under REMOVAL & INSTALLATION. Remove hub cap, wheel bearing nut and washer. Discard wheel bearing nut.
  2. On vehicles with anti-lock brakes, carefully remove rear speed sensor, ensuring speed sensor pole piece does not contact any other components. On all models, remove hub and bearing assembly from axle shaft.
scientia non olet · About LEMON Manuals