LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1992 >> Sundance Base, 2D Hatchback, 2.2 D, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Disc & Drum) >> Removal & Installation >> Axle Hub Bearings: AWD >> Installation

Axle Hub Bearings: AWD: Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1991 Plymouth Sundance, 1991 Plymouth Acclaim, 1991 Dodge Spirit, 1991 Dodge Shadow, and 1991 Dodge Dynasty. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Install inner bearing into trailing arm using bearing remover/installer bar. Apply Grease (2525035) to oil seal lip and install with depression in oil seal lip facing upward.
  2. Install first dust cover over axle shaft and seat against axle shaft shoulder using Dust Cover Installer (MB990799). Install second dust cover with depression facing inboard using same procedure.
  3. Apply grease to circumference of outer bearing where it contacts sealing lip of second (inner) dust cover. Slide outer bearing onto axle shaft, with outer bearing sealing lip surface facing outboard. Press Outer bearing onto axle shaft using Remover/Installer (MB990560).
  4. Slide ABS sensor ring onto axle shaft, with groove in ring facing outboard. Press sensor ring onto axle shaft using remover/installer. Tighten self-locking companion flange nut to 116-159 ft. lbs. (157-216 N.m).
  5. Bleed brake system. See BLEEDING BRAKE SYSTEM  . Adjust parking brake lever stroke. See PARKING BRAKE ADJUSTMENT (DISC BRAKE)  for 4-wheel disc models or PARKING BRAKE ADJUSTMENT (DRUM BRAKE)  for models with rear drum brakes under ADJUSTMENTS.
scientia non olet · About LEMON Manuals