Rear Wheel Speed Sensor: Removal
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 1992 Eagle Premier, 1992 Dodge Monaco, 1992 Dodge Dynasty, 1992 Chrysler New Yorker Fifth Avenue, and 1992 Chrysler New Yorker. However, it is still accessible from the selected car via links, so may be relevant.
- Raise vehicle and remove wheel and tire assembly. Remove sensor assembly grommet from underbody, and pull harness through hole in underbody. Unplug connector from harness. Remove sensor grommet screw from body hose bracket, just forward of trailing arm bushing.
- Remove sensor assembly clip, located on inboard side of trailing arm. Remove sensor wire fastener from rear brake hose bracket. Remove outboard sensor assembly retainer nut.
- Remove sensor head screw. Carefully remove sensor. If sensor is frozen, DO NOT use pliers. Use a hammer and punch to tap edge of sensor ear, rocking sensor from side to side until free.